SL18-20/530 C3 INA

Alle Abmessungen

1. Innen (d) mm 530
2. Außen (D) mm 780
3. Breite (B) mm 140
4. Innen (d) Zoll 20.8661
5. Außen (D) Zoll 30.7087
6. Breite (B) Zoll 5.5118

Suffixbeschreibungen

1. TB In The Case Of Bearings Of TB Design, The Axial Load Carrying Capacity Of Cylindrical Roller Bearings Was Significantly Improved With The Aid Of New Calculation And Manufacturing Methods. Optimum Contact Conditions Between The Roller And Rib Are Ensured By Means Of A Special Curvature Of The Roller End Faces. As A Result, The Axial Contact Pressures On The Rib Are Significantly Minimised And A Lubricant Film Capable Of Supporting Higher Loads Is Formed. Under Normal Operating Conditions, Wear And Fatigue At The Rib Contact Running And Roller End Faces Is Completely Eliminated. In Addition, Axial Frictional Torque Is Reduced By Up To 50%. The Bearing Temperature During Operation Is Therefore Significantly Lower
2. N2 Two Locating Slots (Notches) 180° Apart In One Outer Ring Side Face Or Housing Washer
3. BR Black Finished, Factory-Applied Durotect® B Black-Oxide Coating. Durotect B Improves Run-In Behavior And Energy Efficiency While Reducing Surface-Induced Damage To The Bearing
4. CN/3L
5. CN Normal Radial Internal Clearance. +
6. /3L Clearance Range Corresponding To The Lower Half Of The Actual Clearance Range

Technische Daten

1. Verfügbarkeit 0 St.
2. Marke INA
3. Item number SL18-20/530 C3 INA
4. Also known as NCF20/530V
   
5. Category Zylinderrollenlager einreihig

Gewicht und Abmessungen

1. Gewicht (kg) 245

Produkteigenschaften

1. Bohrung C – Zylindrische Bohrung
2. Dichtung Keine Dichtung
3. Käfigtyp FC – Vollrollig, käfiglos
4. Externe Modifikation Keine Externe Modifikation
5. Interne Radialluft C3 Innenluft (größer als Cn)
6. Präzision Standardpräzision
7. Wärmestabilisierung Keine Wärmestabilisierung - Temperaturen bis 120°C